🚨 EV Crash Safety Module / Pyro Fuse Controller Diagnostics & Repair
Mobile SRS Airbag ECU Repairs, Pyro‑Fuse Reset, HV Isolation Faults & Post‑Crash Recovery
Electric vehicles contain advanced Crash Safety Modules that control:
- Airbags
- Seatbelt pretensioners
- Crash sensors
- Pyro‑fuse activation
- HV battery isolation
- Post‑crash safety shutdown
When a crash is detected, the Pyro Fuse Controller may disconnect the high‑voltage battery to protect occupants and emergency responders. This can leave the EV unable to start, unable to charge, or completely immobilised — even after minor impacts.
FixAnyEV provides mobile Crash Safety Module diagnostics, SRS repairs and pyro‑fuse resets anywhere in London.
📞 Call 07779 836 677 for crash‑safety diagnostics.
⚠️ Crash Safety Modules are life‑critical — incorrect repairs are dangerous. ⚠️ Pyro‑fuse activation disables the HV system and must be reset or replaced correctly.
🔧 What the Crash Safety Module Controls
✔ Airbag Deployment Logic
- Front, side, curtain airbags
- Seatbelt pretensioners
- Occupant detection
- Impact severity calculation
✔ Pyro‑Fuse / HV Battery Isolation
- HV battery disconnect
- HV contactor shutdown
- Emergency isolation logic
- Post‑crash lockout
✔ Crash Sensor Network
- Front impact sensors
- Side impact sensors
- Rollover sensors
- Pedestrian impact sensors
✔ Post‑Crash Safety Mode
- HV system disabled
- Charging disabled
- Drive system locked
- SRS warning active
📞 Call 07779 836 677 for SRS & pyro‑fuse repairs.
🚗 Symptoms of Crash Safety Module / Pyro‑Fuse Faults
- “Airbag Fault”
- “SRS System Fault”
- “High Voltage System Disabled”
- “Service Safety Restraint System”
- EV won’t start after minor impact
- EV won’t charge
- HV isolation fault
- Pyro‑fuse blown
- Seatbelt pretensioner fault
- Crash data stored in SRS ECU
⚠️ A blown pyro‑fuse will immobilise the EV until repaired.
🧠 Common Causes of Crash Safety Module Failure
- Minor collision
- Kerb or pothole impact
- Airbag deployment
- Seatbelt pretensioner activation
- Water ingress in SRS ECU
- Low 12V battery during SRS self‑test
- Incorrect jump‑start procedure
- Corrupted crash data
- Faulty impact sensor
- Pyro‑fuse degradation
🛠️ Our Crash Safety Diagnostic & Repair Process
- Full SRS scan – airbags, pretensioners, crash sensors, pyro‑fuse
- HV isolation status check
- Crash data analysis
- Pyro‑fuse testing & replacement
- SRS ECU reset or replacement
- Impact sensor testing
- Post‑crash HV system reactivation
- Final safety validation
⚠️ Some EVs require secure access to re‑enable the HV system after a crash event.
🔒 Crash Safety ECU Coding & Secure Access
Many EVs require secure access to:
- Reset crash data
- Pair a new SRS ECU
- Re‑enable HV battery contactors
- Clear post‑crash lockout
- Code new pyro‑fuse modules
- Sync SRS with ABS/VCU
FixAnyEV uses EV‑specific tools to safely code and configure crash‑safety modules.
📞 Call 07779 836 677 for secure SRS coding.
🔧 Crash Safety Module / Pyro‑Fuse Repairs We Provide
- SRS airbag ECU diagnostics
- Crash data reset
- Pyro‑fuse testing & replacement
- HV battery isolation reset
- Impact sensor replacement
- Seatbelt pretensioner repair
- Airbag circuit testing
- CAN communication fault repair
- Post‑crash HV system reactivation
🌍 Areas We Cover in London
All London boroughs, including:
- Croydon, Bromley, Lewisham
- Camden, Islington, Hackney
- Ealing, Brent, Hillingdon
- Kingston, Richmond, Sutton
- Central, North, South, East and West London
📞 Book your crash‑safety repair: 07779 836 677
⭐ Why EV Owners Choose FixAnyEV
- EV‑trained crash‑safety specialist
- High‑voltage certified technician
- Correct pyro‑fuse & SRS procedures
- Mobile service across London
- Trusted by EV owners, fleets and traders
📞 Book Your Crash Safety Module / Pyro‑Fuse Diagnostics
FixAnyEV brings expert crash‑safety diagnostics and HV isolation repair directly to your home or workplace.
📞 Call 07779 836 677 to book your SRS / pyro‑fuse repair.